Vogelzang TR008 Manuel d'utilisateur télécharger pdf (Page 15)

TR008-96 | 20120425.0 www.vogelzang.com DURANGO™ | Page 15

coal bed does not obstruct the air inlet. Do not load

fuel to a height or in such a manner that it creates

a hazard when opening the door.

4. Close the feed door and secure tightly.

5. Adjust the air inlet control as described above.

6. Empty ashes regularly. Do not allow ashes

to pile up (see Safety Instructions #14 on

page 2.)

7. Properly dispose of hot ashes (see Safety

Instructions, item #14 on page 2.)

8. Do not over ﬁre the stove (over ﬁring is when

any part of the stove exterior or chimney

connections glow).

CAUTION: DO NOT OVER FIRE APPLIANCE.

YOU ARE OVER FIRING IF THE CHIMNEY

CONNECTORS OR STOVE GLOWS RED. CLOSE

THE DOOR AND SHUT DAMPER IMMEDIATELY

TO REDUCE THE AIR SUPPLY AND SLOW

DOWN THE FIRE.

CAUTION: SLOW BURNING FIRES AND

EXTENDED USE MAY CAUSE EXCESSIVE

CREOSOTE BUILDUP. IGNITION OF CRE-

OSOTE OR OVER FIRING MAY CAUSE A

CHIMNEY FIRE. CHIMNEY FIRES BURN

EXTREMELY HOT AND MAY IGNITE

SURROUNDING MATERIALS. IN CASE OF A

CHIMNEY FIRE CALL THE FIRE DEPARTMENT

IMMEDIATELY.

BLOWER OPERATION

If your stove is equipped with the blower

attachment, follow these instructions for optimal opera-

tion.

LOW (door air control is fully closed to 1/4 open):

Turn the fan on 30 minutes after fuel has been added

and set the fan speed at low.

MEDIUM (door air control 1/4 to 3/4 open): Wait

15 minutes after fuel has been added and set the fan

speed control at high.

HIGH (door air control wide open): Wait 5 minutes

after fuel has been added and set the fan speed at high.

OPERATING continued... SERVICE HINTS

continued on next page

CREOSOTE – FORMATION AND NEED FOR

REMOVAL



slowly, it produces tar and other organic vapors,



creosote. The creosote vapors condense in the



ﬁre. As a result, creosote residue accumulates

on the ﬂue lining. When ignited this creosote

makes an extremely hot ﬁre.

The chimney connector and chimney should



during the heating season to determine if a



If creosote has accumulated (3mm or more)

         

chimney ﬁre.

Failure to remove creosote may result in ignition

and may cause a house/building ﬁre. Creosote may be

removed using a chimney brush or other commonly

available materials from your local hardware retailer.

Chimney ﬁres burn very hot. If the unit or chimney

connector should glow red, reduce the ﬁre by clos-

ing the inlet air control and immediately call the ﬁre

department.

CAUTION: A CHIMNEY FIRE MAY CAUSE IGNI-

TION OF WALL STUDS OR RAFTERS WHICH

WERE ASSUMED TO BE A SAFE DISTANCE

FROM THE CHIMNEY. IF A CHIMNEY FIRE

HAS OCCURRED, HAVE YOUR CHIMNEY IN-

SPECTED BY A QUALIFIED EXPERT BEFORE

USING AGAIN.

A ﬁre in the ﬁrebox may be smothered by pouring

a large quantity of coarse salt, baking soda, or cool

ashes on top of the ﬁre.

PREVENTING CREOSOTE BUILDUP

1. Creosote will inevitably form in your chimney and

connector pipe. Following these steps will help

reduce the rate of build up.

2. BURN ONLY SEASONED WOOD that has dried

for at least one year.

3. Burn hardwood rather than softwood. Hardwood

is denser or heavier wood and burns hotter.

4. Do not attempt to burn (or mix in) green or wet

wood. The use of green or wet wood will cause a

rapid build up of creosote. Wood that hisses, sizzles

and blackens without igniting in ﬁve minutes must

be considered too wet to burn.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Vogelzang TR008 Manuel d'utilisateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Four Vogelzang TR008